1 |
Slide, complete with Fixed Front
Sight, Adjustable Rear Sight, Extractor, Firing
Pin, Firing Pin Spring and Firing Pin Stop. |
2 |
Barrel |
3 |
Floating Chamber |
4 |
Ejector |
5 |
Bushing |
6 |
Recoil Spring, Recoil Spring
Guide and Plug |
7 |
Magazine |
8 |
Slide Stop |
Instructions for
Assembling Conversion Unit On
.45 Caliber Colt Automatic Pistol Receiver
To Remove .45 Caliber
Slide
Remove the magazine by
pressing the magazine catch. (After removing magazine, look
to see that there is no cartridge left in the chamber.)
Press the recoil spring plug
inward with the index finger of the right hand. Turn barrel
bushing to the left until the plug is free to go forward;
then release tension on the spring gradually to prevent plug
from jumping away. Draw slide back until the rear edge of
the smaller recess in the lower edge of the slide is even
with the rear end of the slide stop; press against end of
slide stop which projects from the opposite side of the
receiver above the trigger guard, and draw out the stop.
This releases the barrel and
slide, which may then together be drawn forward from the
receiver, carrying also the barrel bushing, recoil spring,
and recoil spring guide.
It is not necessary to remove
stocks as all parts of the pistol can be dismounted and
assembled with the stocks in place.
In taking the pistol apart,
use no hammer, as dismounting and assembling is quick and
easy after a little practice.
The hammer should not be
snapped when the slide is removed from the receiver.
To Install.22-.45
Conversion Unit Parts
Insert floating chamber in
breech of barrel, with ear engaging in slot in barrel lug.
Fit ejector into groove in barrel. With slide in inverted
position, insert complete unit into slide through front
opening. Be sure ejector slides easily into groove above
firing pin.
Place recoil spring on recoil
spring guide and push spring through opening in front of
slide, with guide resting on barrel. Push receiver gently
onto slide, engaging corresponding grooves. Insert slide
stop through hole in receiver, making certain that it also
passes through hole in barrel lug. (Note that special slide
stop is provided for use with .22-45 Unit.) Barrel may be
forced slightly to front or rear to bring lug opening into
line with hole in receiver. Now force slide to rear until
small cut in slide is directly above square opening in
receiver. Press the slide stop all the way in. Insert barrel
bushing in front opening of slide turning as far to left as
it will go. Now place the recoil spring plug on end of
recoil spring, and turn plug to right to engage spring.
Press plug firmly toward rear of pistol and then turn barrel
bushing to a downward position, to hold plug in place.
Insert magazine and arm is ready to function with caliber.
22 Long Rifle cartridges. We recommend the use of greased
type ammunition.
Magazines
Note: Magazine furnished with
Standard Colt Ace Automatic Pistol will not function with
this unit.
Reasonable care should be
taken to keep the magazines from being dented or otherwise
damaged. When placing loaded magazine in the pistol, never
push part way in and then strike it with the hand to drive
it home as it might spring the bottom plate or the inturned
lips at the top of the magazine; it should be inserted in
the handle by a quick, continuous movement, but not slammed
into place hard enough to cause damage.
Use nothing but thin oil for
oiling the arm.
As soon as possible after
firing, the inside of the barrel should be cleaned and
oiled.
Occasionally a little oil
should be put on the friction points, not forgetting ends of
the safety lock and slide stop plungers. |